Instruction Manual
Instruction Manual
Print
Print

MC310

The MC Monitors are designed to continuously monitor pH, EC or TDS values directly in your reservoir. Each unit features a user selectable set-point. An LED visual alarm is activated and flashes when the pH, EC or TDS level rises either Above or Below (user selected) that set-point.

All these instruments run on a 12V adapter so there's no need to worry about failed batteries and each unit comes with mounting kit, probe, probe holder and starter calibration solution.

Professional EC - Conductivity Monitor

  • User selectable Hi/Low Set Point

  • Manual 1 point calibration

  • Visual LED alarm

  • Supplied with 12 VDC adapter, mounting kit, and 20ml 1413 µS/cm calibration solution

  • MA811/2 EC Conductivity Probe with 2m cable (BNC connector)
MA811/2

MA812/2
Conductivity probe with 2 m cable

Calibration, Maintenance & Cleaning Solutions
Choose from our wide selection of calibration, maintenance and cleaning solutions.
SPECIFICATIONS
Range 0.0 - 10.0 mS
Resolution 0.1 mS/cm
Accuracy ±2% Full Scale
Setpoint range
1 - 5 mS
Alarm Active when reading is higher or lower than set point
Probe MA812/2 (included)

 

ACCESSORIES
MA811/2 Conductivity probe with 2 m cable
M10031B 1413 µS/cm calibration solution,
20 ml sachet (25 pcs)
M10032B 1382 ppm calibration solution,
20 ml sachet (25 pcs)
M10039B 5.00 mS/cm calibration solution,
20 ml sachet (25 pcs)
M10442B 1500 ppm calibration solution,
20 ml sachet (25 pcs)
ORDERING INFORMATION
MC310 is supplied with 12 VDC adapter, mounting kit, and 20ml 1413 µS/cm calibration solutio.