Instruction Manual
Instruction Manual
Print
Print

MC410

The MC Monitors are designed to continuously monitor pH, EC or TDS values directly in your reservoir. Each unit features a user selectable set-point. An LED visual alarm is activated and flashes when the pH, EC or TDS level rises either Above or Below (user selected) that set-point.

All these instruments run on a 12V adapter so there's no need to worry about failed batteries and each unit comes with mounting kit, probe, probe holder and starter calibration solution.

TDS - PPM Monitor

  • User selectable Hi/Low Set Point

  • Manual 1 point calibration

  • Visual LED alarm

  • Supplied with 12 VDC adapter, mounting kit, and 20ml 1382ppm calibration solution

  • MA81/2 PPM Probe with 2m cable (BNC connector)

Calibration, Maintenance & Cleaning Solutions
Choose from our wide selection of calibration, maintenance and cleaning solutions.
SPECIFICATIONS
Range 0 - 1990 ppm
Resolution 10 ppm
Accuracy ±2% Full Scale
Setpoint range 700 - 1800 ppm
Calibration
Manual 1 point
Alarm Active when reading is higher or lower than set point
Probe MA812/2 (included)

 

ACCESSORIES
M10031B 1413 µS/cm calibration solution,
20 ml sachet (25 pcs)
M10032B 1382 ppm calibration solution,
20 ml sachet (25 pcs)
M10039B 5.00 mS/cm calibration solution,
20 ml sachet (25 pcs)
M10442B 1500 ppm calibration solution,
20 ml sachet (25 pcs)
ORDERING INFORMATION
MC410 is supplied with 12 VDC adapter, mounting kit, and 20ml 1382ppm calibration solution.